1
Non-FE Discussion Forum / Re: Jay’s B9 reproduction carb
« on: Today at 12:46:26 PM »
Holy cow.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
jay made a a place for non fe builds at the first of the year,but after a short time it vanish.not sure why.
but i likeseeing other ford engines on here and i think most users have other fords,not just fe.and dont blame lykins for lower thread count,thats on fb!
Question about purchasing complete internally balanced rotating assemblies. Are the matching components stamped or otherwise marked? Do the wrist pin/rod/pistons come assembled? Wondering how the end user knows which components go where.
When it comes to machine the block are the following what you'd ask the machine shop to perform:
Clean block
sonic check/magnaflux
Bore/hone cylinders (with torque plate?)
Square deck block
align hone main bearing caps
Cam bearing install
I have two candidate blocks, one is 4.050" bore the other is 4.080". Is there a reason to use the 4.080" block? Is it better to perform oiling system modifications prior to the machine shop work?
That's really interesting. I guess the overly simplified analogy would essentially be that as airflow improves, the less duration is needed to make power. Thanks, for taking the time to explain that Brent.
Did you mean cam on the big side for the factory headed engine?
I'd do the bottom end first. You can swap heads in the vehicle. You could always cam for the heads you plan to switch to.
This answers a question I've been wondering about for awhile now regarding using a cam spec'd for a different set of heads that will be the "end game" for the engine. Thanks for throwing that out there Brent.
Say you wanted to end up with an aluminum headed 445 stroker, but didn't have the funds to handy to do it in one step. Would your two step approach be:
A. Heads/custom cam now; add 445 bottom end later
or
B. 445 bottom end first and choke it out with OE heads until future replacement with TFS/BBM heads.