« previous next »
Pages: [1]

Author Topic: Aluminum intake fittings  (Read 1180 times)

0 Members and 1 Guest are viewing this topic.

69Shakar

  • Jr. Member
  • **
  • Posts: 48
    • View Profile
Aluminum intake fittings
« on: October 06, 2019, 07:11:49 PM »
I’m close to installing my 428 ..waiting for the headers . So I’m trying to get as much installed as I can. I’ve found aluminum heater hose fittings but the only thing I’m finding for the vacuum tree is steel or brass. What would be the choice for an aluminum intake? And since the rpm vacuum port is on the front was going to run hardline to the back for brake booster and trans modulator.
Logged

machoneman

  • Hero Member
  • *****
  • Posts: 3859
    • View Profile
Re: Aluminum intake fittings
« Reply #1 on: October 06, 2019, 07:18:17 PM »
If a choice, I'd go brass. Either way though, some anti-seize compound would allow easy removal.
Logged
Bob Maag

67428GT500

  • Hero Member
  • *****
  • Posts: 694
    • View Profile
Re: Aluminum intake fittings
« Reply #2 on: October 06, 2019, 10:25:25 PM »
Depending on how you're installing it you may want to leave the fittings off until it's in.
Logged
Pages: [1]
« previous next »