Next mission on this project:
-Idle air bleed is .067, I'll change it to .070, or .074 to lean up the idle a fuzz. Ifr is small at .031, secondary ifr .033
-With Mixture screws 3/4out I can only get a 12/1 afr, would like a lil better control with the screws so I can find both ends of the "happy range"
-All four pump nozzles are .031, it was the smallest set of four I had laying around, I'll buy four .025's and find the smallest one that works, just drill .001 at a time until I get rid of any issue there.
-test drive and see how the main's work. Currently have 68 jets, Metering plate drilled to .080, Power valve is currently 8.5 with .057 pvcr. Good cruise will point me in which direction I need to change these.
Fun little project, happy I took it on.
I've got at least two 600/650/700/750/800/850 double pumpers, so I may make a set of each just to find what calibration works for each.
Thanks all for the input/feedback.