Milodon windage tray, anyone use one?

[My427stang]

Has anyone used a Milodon FE windage tray, P/N 32224

Loosely looks like a Ford version, but a little different.  Mostly wondering if any clearance issues or dipstick issues, going in a 4.25 stroke TFS headed 461, Molnar rods

Thanks!

[CaptCobrajet]

I use the Canton screen.  20-938.  No problem on any of the stroker combos.   It rubs the pick-up tube on a Canton T-pan, but easy to clearance that without getting it too close to the rods on the top side.  I just don't like that stuff touching.  I think the screens are better than solid or louvered, just my opinion.

[My427stang]

Thanks, just asking about the Milodon though. I agree though, Canton is good stuff

[Barry_R]

I tried the Milodon.
Took considerable effort to make it fit.
I use the same Canton as Blair on almost all of my builds, along with Moros pan & pickup

Sometimes there is a reason when we all end up in the same place....

[My427stang]

Thanks Blair and Barry, Canton fan here too but always like to see alternatives, especially when it’s quiet on the net about a part.  It was almost like the interweb thought nobody had used one until you guys chimed in. 

[cammerfe]

I, too, use the Canton screen. I found it necessary to bend the tip of the dipstick just a bit to get it to clear. Just a little, still slid down the tube just fine.

KS

[My427stang]

OK, so this one is on a timeline, and you guys spooked me enough to get both the Canton and the Milodon. 

If the Milodon doesn't fit, I'll have a backup plan.

More to come, thanks!