Deeper pilot bushing source?

[ntheogen]

Anyone have a source for a deeper pilot bushing to run a truck bell with a short snout 390 style Toploader?

Thanks
Jack

[fairlaniac]

I don't but here are pics of a few I use to have. Maybe a search by Compo name could help? C5TZ-A.

[fairlaniac]

Maybe these? https://www.ebay.com/p/Old-Stock-OEM-1965-Ford-Truck-Clutch-Pilot-Bearing-2-Pcs-C5tz-7600-d/1036802192?iid=143079877806&chn=ps&norover=1&mkevt=1&mkrid=711-117182-37290-0&mkcid=2&itemid=143079877806&targetid=313776935016&device=c&adtype=pla&googleloc=9006769&poi=&campaignid=1669934603&adgroupid=65058347419&rlsatarget=pla-313776935016&abcId=1123856&merchantid=7873484&gclid=Cj0KCQjwjYHpBRC4ARIsAI-3GkE-wHdMQM-5mCs0r1apPtGD7SOjAm42YeydRHy-LjX0sdJCwtS2cOIaAudGEALw_wcB

[fe-starliner]

Jack, it's been about 12 years, but I bought the pilot bushing you are looking for at O'Reilly Auto Supply.  I also used a truck bell and the deep bushing did the trick.  But I could never get the air gap adjusted properly with the clutch until I bought a truck throwout bearing that is used with the truck bell.

[ntheogen]

Thanks Doug, I wasn't aware that Ford ever made one and the ones I have seen have been solid without a recessed area. It's hard to tell if that's what I'm looking for without having it in my hands.



I'll check with Oriellys.

[427HISS]

I bought three from different company's, Summit, Jegs etc., and did not like any, so a friend that's a machinist made mine. Came out perfect, with 1/2" sitting on my Tremec shaft very happy.

[wayne]

John Vermeersch  may have one in stock. 586-468-3673

[ntheogen]

He doesn't, but thank you.

[TomP]

Is that C5TZ-A a standard size pilot? (.667")
I have a heavy truck tranny that uses the big clutch and the pilot tip is a lot larger diameter than a car tranny.