Wtb 427 pistons

[67xr7cat]

Looking for a good set of 427 flat top pistons for a 4.25" bore.

[garyv]

I have a new set of JE pistons for a 4.25 bore but they have a small dome for a MR head.
They were $1100 new and need rings and pins. 
$575 plus shipping.

garyv
Here's spec sheet

[67xr7cat]

HI thanks, but looking for a flat top or small dish. Also not looking to spend a lot $$$. If can find pistons and rods at reasonable price will keep it a 427. Is easy to have $1500 in pistons, rods, bearings and rings. At that point makes sense just get a stroker kit for another $500. Anyway figured see what is out there, thanks Steve

[dmazz]

I have a set that are dished, from a marine engine. $50 bucks plus shipping

[67xr7cat]

Hi, what shape they in. Are they cast or forged? Any pictures? Thanks Steve

[dmazz]

in good used condition, I will take pictures and post them. You can call me 7242376280 Denis

[Kevin66]

Well, this isn't exactly what you're asking for here, but I'll throw it out.
I have a good set of Ross forged, flat-top 427 FE pistons at 4.258" (approximately .025" O/S).
They have two valve reliefs (fairly deep), weigh 800 gms, comp height is 1.875", they come with pins, and have been glass beaded.
They were run in a new engine for 'dyno time only' before deciding to go another route.
I don't think I can post pictures, but I could e-mail them.

[67xr7cat]

I think I've found a set of pistons, but may be interested in yours too. Is the CH a typo? I'd think it should be 1.775".

How much do you want for the pistons? Thanks, Steve

[Kevin66]

Yes, you're right. I must have gone dyslexic for a moment, as what the machinist actually wrote on them is 1.765".
I'm looking to get $350 for them.

[67xr7cat]

Thanks for posting them. Think going to stay with the set I found. Thanks again, Steve

[fe the only choice]

Steve I have a set of marine rods and pistons if u ever need engine was renewed installed and started
Then found to be cracked up by timing cover... new crack on me. Anyway no run tine just got oil on them rods were gone thru also



Thanks Luke

[67xr7cat]

Hi Luke,

Thanks. Have you looked into getting the block repaired? Are some newer ways like loc-n-stitch. Sounds like yours may be a candidate.