Author Topic: Advice on a 390 block for stroking (Read 2245 times)

1Bad500 · « **on:** March 17, 2019, 11:45:33 PM »

Looking at buying this for my stroker build. Good deal? Any concerns? All machine work is done except the bore/hone & decking.

ntheogen · « **Reply #1 on:** March 18, 2019, 12:49:50 AM »

I say pull the trigger, you couldn't replicate one for that money. I have a 64 block like this that I had plans on doing the same thing too.

Tommy-T · « **Reply #2 on:** March 18, 2019, 01:12:03 AM »

If you don't get it...I might. Let me know if you pass.

Tommy

BattlestarGalactic · « **Reply #3 on:** March 18, 2019, 07:11:31 AM »

What a bargain!! Wish I was about 3000 miles closer.

fryedaddy · « **Reply #4 on:** March 18, 2019, 10:45:54 AM »

you better already have this bought.a lot of fe people would gobble this up even if they didn't need it. i would

1Bad500 · « **Reply #5 on:** March 19, 2019, 10:49:56 AM »

I’m out of town this week but the guy said he will hold it for me. I will post a few better pictures on Saturday when I pick it up.

Should make a good starting platform for a 445” Stroker.

1Bad500 · « **Reply #6 on:** March 23, 2019, 09:44:31 PM »

Well... I see one thing wrong with my new purchase. 1-3/4" freeze plugs. Hope this was a good buy.

gt350hr · « **Reply #7 on:** April 01, 2019, 10:29:19 AM »

Lindvig Machine does high quality work. No problem there.

News: