Author Topic: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill  (Read 2574 times)

0 Members and 1 Guest are viewing this topic.

chris401

  • Guest
MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« on: November 01, 2016, 05:00:22 AM »
Was that 6 superior to the Ford 534 and International 549?

STORY BELOW


Some of those old engine were pretty tough- I had a 10-wheel dump with the old "Lincoln Y-block" 332/ Allison automatic, and rebuilt it a couple times, probably had 10 different drivers in it, and couldn't hurt it. Very similar to a regular Y-block but bigger- also had a 2-gear driven cam, so the cam ran "backwards". Also have had 330MD, 361, and 391HD's and worked on 'em all, and a 534SD- as well as Binders with 345, 392, and a 549- another beastly old gasser. The 534 and 549 did like their gas if you pushed 'em hard, but would also show their tailgates to most of the average diesels of the day if you really let them eat- I saw a few guys wise off to folks, passing them with 220 or 250 Cummins and 6-71 238hp Screamers (running wide open) powered trucks, and laughing at them or shooting them the bird, and then get passed right back by those old gassers :confused: :( One of the guys had a '69 F-Super Duty with a 534, and had straight pipes with no mufflers that exited to the side right by the mudflaps- if you passed him, he'd split your eardrums when he passed you back :eek:
Funniest one I saw was one of the guys drove an old 50's Diamond-T with a Binder RD501 six in it, a pretty good torque monster (a lot of guys have swapped 501's into early pulling tractors) who always drove in fuel economy mode, and the truck was a bit of a rat that he had bought from a septic service contractor and still had their name on the doors, so you can imagine it's nickname :rolleyes: All the young bucks would pass him and pick on him about it, he'd just grin. So he gets passed one day on "Howard Hill" by a kid in a new Mack with a Maxidyne in it, and gets the bird as he goes by- now this old wreck had one of those big cowcatcher/radiator guard bumpers on it that they like back east, so he kicks it a little, and butts up against the back of the Mack, and proceeds to push him up the hill for about a 1/4 mile- then backs off, pulls out and passes him- holy embarrassment, Batman- nobody gave him any "crap" about his "sh^!box" after that
MAY 31, 2011
« Last Edit: November 01, 2016, 10:26:30 AM by chris401 »

chris401

  • Guest
Added Story From HAMB NM
« Reply #1 on: November 01, 2016, 10:25:41 AM »
NM

57 lima bean

  • Guest
Re: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« Reply #2 on: November 01, 2016, 02:46:36 PM »
Is this what you were after?...........   http://www.jalopyjournal.com/forum/threads/ford-mel-engines.83385/

chris401

  • Guest
Re: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« Reply #3 on: November 01, 2016, 03:21:33 PM »

MeanGene

  • Sr. Member
  • ****
  • Posts: 470
    • View Profile
Re: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« Reply #4 on: November 02, 2016, 06:45:13 AM »
The 501 was the largest six, and a torquer. 534 and 549 were more modern V8s and needed a little more rpm to make their best power- but still governed at around 3400

chris401

  • Guest
Re: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« Reply #5 on: November 02, 2016, 08:18:14 AM »
I was wondering being inline if they made lower power. Dad drove a loud one seater dump truck. That might have been the Screamin Demon I have heated about.

NIsaacs

  • Sr. Member
  • ****
  • Posts: 302
    • View Profile
Re: MeanGene= Good Story= Binder 501 VS A Maxidyne On Howard Hill
« Reply #6 on: November 04, 2016, 09:53:18 AM »
Big truck stories are always good! I cut my eye teeth in the Log Woods hauling with a '63 Mack 205 Thermodine. Hauled a lot of cows and dirt with RD450, 549 IHC's and 534 Fords.

Per my '62 Motors Manual, here are some specs:

RD501: 212 HP@3000, 560 TQ@1600
IHC 549: 256 HP@3200, 505 TQ@2000
Ford 534: 270 HP@3200, 481 TQ@1900
Mack ENDT 673: 205 HP@2100, 560 TQ@1400
GM 6-71: 219 HP@2100, 574 TQ@1600

So yes, at or close to sea level the Gassers run good but at high elevation the Turbo of the Mack and Supercharger of the GM will show tail lights to them!

Nick
2021 Ram 2500 4x4 Cummins of course!
2017 Ford Escape, 2.0 Eco Boost
2001 Ram 2500 4x4 QC short bed, Cummins, 6spd, some mods
1991 Dodge D250, reg cab, Cummins, 5spd, mods
1974 F-350, Cummins, 5spd, 3spd aux, mods
1975 F-250 4x4, 428, C-6, Sled Puller