« previous next »
Pages: [1]

Author Topic: Cylinder wall finish  (Read 2048 times)

0 Members and 1 Guest are viewing this topic.

fekbmax

  • Hero Member
  • *****
  • Posts: 1458
    • View Profile
Cylinder wall finish
« on: December 01, 2015, 06:25:52 PM »
Cylinder wall finish for moley rings, ? What's your guys thought's.. ??
Logged
Keith.  KB MAX Racing.

machoneman

  • Hero Member
  • *****
  • Posts: 3853
    • View Profile
Re: Cylinder wall finish
« Reply #1 on: December 01, 2015, 07:57:49 PM »
Logged
Bob Maag

Falcon67

  • Hero Member
  • *****
  • Posts: 2159
    • View Profile
    • Kelly's Hot Rod Page
Re: Cylinder wall finish
« Reply #2 on: December 02, 2015, 10:19:51 AM »
I used a 320 grit Flex Hone to put in a fresh surface for moly in the 351C for the Mustang.  The bores were straight, just wanted a little fresh surface for ring seat.  I did buff the bores a bit with green scrub pads, then washed them extensively.  Rings seated immediately, no oil use.
« Last Edit: December 02, 2015, 10:22:56 AM by Falcon67 »
Logged
Pages: [1]
« previous next »