Anyone have a set of 6114 Hookers around for some measuring?

[My427stang]

If anyone does, I need a minimum height and width of the exhaust port flange ID where it meets the head, and how much weld ring there is from that edge.  example L x W and minimum of .250 sealing surface

Thanks!

[2ndgear]

I was not happy with the weld ring on my headers.
What I did was tig weld up the outside flange to header pipe
and then remove the weld ring by resurfacing the whole flange
that bolts to the head. After resurfacing I cut the flange between
every exhaust port. Also by doing that I was able to gain some
more clearance in the shock tower mustang by resurfacing. By doing
that I got 100% seal around the port. They been on the car for over
10 years without any leaks. I dont know the measurements because
they are on the car and hard to get at. Hope this helps some.

[My427stang]

Appreciate your response, but not trying to seal a set, trying to do some planning for compatibility with a modified set of heads

[GerryP]

I was not happy with the weld ring on my headers.
What I did was tig weld up the outside flange to header pipe
and then remove the weld ring by resurfacing the whole flange
that bolts to the head. ....

Not intending to sidetrack the thread, but the best quality and real race headers are built just as you did.