« previous next »
Pages: 1 [2]  All

Author Topic: Front timing cover alignment tool and source for new spacer  (Read 3811 times)

0 Members and 1 Guest are viewing this topic.

blykins

  • Hero Member
  • *****
  • Posts: 5178
    • View Profile
    • Lykins Motorsports
Re: Front timing cover alignment tool and source for new spacer
« Reply #15 on: December 29, 2025, 02:05:44 PM »
I've never seen a new cast iron one, they are all usually steel. 
Logged
Brent Lykins
Lykins Motorsports
Custom FE Street, Drag Race, Road Race, and Pulling Truck Engines
Custom Roller & Flat Tappet Camshafts
www.lykinsmotorsports.com
brent@lykinsmotorsports.com
www.customfordcams.com
502-759-1431
Instagram:  brentlykinsmotorsports
YouTube:  Lykins Motorsports

66FAIRLANE

  • Hero Member
  • *****
  • Posts: 594
  • Andy
    • View Profile
Re: Front timing cover alignment tool and source for new spacer
« Reply #16 on: December 29, 2025, 09:27:14 PM »
Quote from: blykins on December 27, 2025, 09:38:58 PM
What's nice about the tool is that it locates in the seal bore and centers on the crank. 

I thought the seal went in from the back? How does the tool locate on the seal bore?
Logged

blykins

  • Hero Member
  • *****
  • Posts: 5178
    • View Profile
    • Lykins Motorsports
Re: Front timing cover alignment tool and source for new spacer
« Reply #17 on: December 30, 2025, 06:41:14 AM »
It does go in from the back, but leaves a lip on the front side of the timing cover, big enough to locate off of. 
« Last Edit: December 30, 2025, 06:46:09 AM by blykins »
Logged
Brent Lykins
Lykins Motorsports
Custom FE Street, Drag Race, Road Race, and Pulling Truck Engines
Custom Roller & Flat Tappet Camshafts
www.lykinsmotorsports.com
brent@lykinsmotorsports.com
www.customfordcams.com
502-759-1431
Instagram:  brentlykinsmotorsports
YouTube:  Lykins Motorsports

c9zx

  • Full Member
  • ***
  • Posts: 119
    • View Profile
Re: Front timing cover alignment tool and source for new spacer
« Reply #18 on: December 30, 2025, 01:13:25 PM »
Brent, The web site says cast iron. The person I spoke to said steel. I will know today. Chuck
Logged
1969 Eliminator G code
CSX-7031 FIA Cobra
2007 Mustang GT, Whipple
1966 Cyclone GT

Dr Mabuse

  • Jr. Member
  • **
  • Posts: 97
    • View Profile
Re: Front timing cover alignment tool and source for new spacer
« Reply #19 on: December 30, 2025, 08:28:26 PM »
Again, from my Ford Shop Manual
re:
Logged
Pages: 1 [2]  All
« previous next »