Cam Doctor Cam Measuring Service

[DuckRyder]

Does anyone know who still offers this service, where a cam can be sent and measured?

I see Cam Research offers break in service, but they don't say anything about measuring profiles.

[GerryP]

I think Mike Jones does profiling:  http://jonescams.com/

If not, then he'd know who does.

[Phil Brown]

Might also try Powell Machine
(864) 348-7582
powellmachineinc@gmail.com

[blykins]

I can do it for you through Comp Cams.

[DuckRyder]

Thanks Brent, I'll be in touch if i cant get numbers from Edelbrock/Comp. I've asked.

Actually, I'll be in touch anyway for something else.

Thanks!

[blykins]

Thanks Brent, I'll be in touch if i cant get numbers from Edelbrock/Comp. I've asked.

Actually, I'll be in touch anyway for something else.

Thanks!

What numbers are you looking for? 

[DuckRyder]

This is with respect to the Edelbrock roller i had asked about.

https://fepower.net/simplemachinesforum/index.php?topic=12135.msg132216#msg132216

I was looking for the seat to seat on it and everywhere i find gives the same for ADV and .050. Even though im not going to actually use it its bugging the fool outta me that i cant find the numbers so if they wont reply to my e-mail i might have one profiled for science. I know i'm weird.

Since i'm pretty much sure Comp grinds this, they should already know anyhow though right?

[blykins]

Give me a minute and I'll get it.

[blykins]

Advertised durations are 281/287.

228/236 @ .050", 281/287 advertised, 107 ICL, 117 ECL, .353"/.367" lobe lift. 

Pretty aggressive lobe.   More aggressive than what I like to see on an FE head with heavy valvetrain.

[DuckRyder]

Thanks Brent.

Does seem pretty aggressive.

[pbf777]

I was looking for the seat to seat on it ........................... so if they wont reply to my e-mail i might have one profiled for science. I know i'm weird.

      Just note, that one can "profile" a camshaft as installed in a block with a lifter, dial indicator, degree wheel, paper & pencil.   

      So, if you want a science project, go for it!   

      Scott.

[DuckRyder]

LOL,

I didn't want that much science... im also fresh out of bare blocks... I hope...