Spark plug wire kits recomendation.

[james]

I have been getting various opinion on this issue. I have a 427fe stroked to 482. This is one set of wires that was recommended. Taylor 409 Pro Race Spiro-Wound 10.4mm Spark Plug Wires 79665, 10.44mm.
Then someone told me about Taylor 409 pro race universal spark plug wire set #79691 10.44mm. What say you guys? Any other recommedations and price is not a main concern. Thank You!

[Barry_R]

I use MSD stuff.  The 10.5mm on most racy builds, the less expensive Streetfire ones where we need them to work with factory valve coves and wire looms.

[james]

Thank you Barry. I bought your stroker kit for the motor. Can you please provide me with some part numbers? Thanks again.

[Barry_R]

Going by memory (at home right now) the MSD race set is 31183 - black with multi-angle plug ends and both distributor ends.

[JamesonRacing]

I've had good luck on my street stuff using the Ford Racing M-12259-M302 cut-to-length black wires, then using MSD boot kit for the distributor side to fit my OEM plug style distributor cap.  Gives a nice thick wire with each cylinder labeled along the wire.  The pre-made stuff can make the connections but they usually don't dress as nice as when you cut each one to the exact length you want.

[Falcon67]

Think I sued Taylor 8mm universal on the dragster, would have to go look at the invoice.  I know I'm using their wire management parts.  Picked by price and color blue.  Normally over the years I have run 8mm yellow Accel wires and never had any problems.  The primary color scheme on the dragster is purple and blue, so yellow would clash.