Mahle 1mm 1mm 2mm ring package

[MeanMofakee]

Try this once more. Posted in the wrong forum before. Found out the pistons and rings that are in the stroker kit I bought has the Mahle 1mm 1mm 2mm ring package. Any opinions, good bad or indifferent!

[jayb]

I've never run those, but I've run the 0.043/0.043/3mm ring package with good results.  First two rings are almost the same (1mm=0.040").  No reason those won't work for you...

[machoneman]

Many new cars run those same rings for less drag, better sealing and improved mileage (less drag).  Pro Stock engine also run thin rings...likely even thinner! 

[blykins]

Good rings. 

Most of my pistons are either 1/1/2 or 1.5/1.5/3.  No problemo.

[cjshaker]

I'm no expert, but with that thin a ring, I'd think bore and taper must be pretty tightly controlled?

[Barry_R]

Best production ring package I have used to date.  Run them in everything I can.  Very low friction and seal up instantly.

[FirstEliminator]

Best production ring package I have used to date.  Run them in everything I can.  Very low friction and seal up instantly.

   That is a wonderful thing to hear.

[MeanMofakee]

That's good news guys, thanks

[Barry_R]

... I'd think bore and taper must be pretty tightly controlled?

This portion of your statement should always be a "given fact".

[chris_r]

+2 Barry    I have a lot of small bore fe's with 1,1,2 ring package.  Work great i also run them in everything i can.

[cjshaker]

... I'd think bore and taper must be pretty tightly controlled?

This portion of your statement should always be a "given fact".

Unfortunately, that's not always the case, so you'd better be sure about your machinist.