Crower cool-face solid lifters push rod question

[63.5xl]

Has anyone used the 66915X980 crower cool-face lifters. Just wondering what the push rod length they ended up with using stock adjustable rockers. I have a pushrod checker if I decide to order the lifters but it only goes up to 9 1/2 inches. Are they longer than that?

[63.5xl]

After some searching I found where DSC, says a 10.400 pushrod is need for solids with shell lifters so I will have to another push rod checker that goes from like 10 inches to 11 inches to measure my for sure.

[ScotiaFE]

It can't be that difficult to make the push rod checker longer.
An extra bit of threaded rod or something along that line.

[My427stang]

You are likely correct for a shell lifter, but I don't think that is a shell lifter Carl.

A shell lifter is generally a hollow cup and could not really be made to oil at the face.  I could be wrong, but I believe those are simply a SBF lifter

This is a poor picture, but you can see down inside the lifter

[Drew Pojedinec]

Ask Brent Lykins.  He uses them all the time.

On another note, once I'm done getting my rockers test fit, I'll be measuring for pushrods with these lifters.  (couple days)

[63.5xl]

You are likely correct for a shell lifter, but I don't think that is a shell lifter Carl.

A shell lifter is generally a hollow cup and could not really be made to oil at the face.  I could be wrong, but I believe those are simply a SBF lifter

This is a poor picture, but you can see down inside the lifter

You are right Ross, after checking and talking to Crower, the seat height on the cool-face lifter is 1.640 where the seat height on the dumbell that Howards Cam has is 1.796 and the dumbell that comp has is 1.790, so not a big difference like the shell lifter would be. Comps shell lifter 837 shows a seat height of only 0.470, a big difference.
I ordered the crower cool-face lifters from Brent this morning.
Carl