FE Power Forums > Non-FE Discussion Forum
Mickey Thompson Pro 5 ET Drag wheel?
(1/1)
fe66comet:
Anyone using a set? They are even lighter than any Weld wheel out there, was wondering if anyone has had an opportunity to work with them yet. They are a new product and look promising for my Drag truck.
cwhitney:
I have them on my 67 Fairlane B/S Stocker and never had any issues.. very light.. easy to balance.. I would recommend them. I did not put wheel screws in them either. I run the 15 by 10, and the 15 by 3 1/2 on the front. Hope this helps
fe66comet:
Just wondering if someone had used them. Sounds good, and cheaper than a lot of race wheels out there. Almost too good to be true LOL.
Navigation
[0] Message Index
Go to full version