Hi Jay---
I haven't talked much about it much, anywhere, but I'm at work on the beginnings of a Land Speed car. It'll be based on an aftermarket version of the '06 Ford GT.
When you have a chance, could you measure the transaxle length from the back face of the block to the centerline of the half-shafts on your car? This measurement will make it possible to ascertain possible alternatives available to me. M2K is using a Ricardo, I believe, but I'll be trying to get close to twice the claimed 2500 HP they're putting out. It's been suggested that it'll be necessary to use a combo of slipper clutch in a can and some Lenco pieces attached to a Top Fuel center section.
The measurement I asked for will give me some idea as to where I'll have to start splicing.
Thanks much!!!
KS