OK well I pulled the intake and head and I try and prime it and still no oil, I mean I let it run for at least 45 to 60 seconds, gauge reading 100psi ( I plugged the drivers side head ) then I go look at the head gasket again and nothing looks out of order. Now Im figuring something is blocking it like a cam bearing not installed properly maybe like Brent suggested. I go back over to it and pull the roller lifters out most of the way from cyl # 3 and it makes some slight gurgling sounds from the oil on the lifter and lifter bore Im guessing. I go to prime it again and in like 5 seconds I have oil coming out of the block now ?!?! I probably had a total of at least 10 min of priming time along with rotating the engine at the same time too. I just cant figure out what the hell was going on but it pumps the oil just like the other side now.