So I went to Toll welding where I lease my gas cylinder from to buy some wire. The only 2lb spools they had were made in china so I went to Home Depot and bought a spool of Lincoln L56 wire from them. After laying on my back/side grinding away most of my splattered welds on my subframe connector. I clamped an angle iron in the vise and set my gas flow from 25 to 20 and did a test weld. What a difference!!. I was able to weld upside down with no weld nuggets dripping down. I went over to the car and it welded up very easy. I wish I had this wire when I started. Jim
