After making a " call " it appears that only the first run of valve bodies, had the Broader Performance logo, someone noticed and now the valvebodies have the Speedmaster logo. Speedmaster did reverse engineer, the Broader valvebody, and there is not much, that will come of that, ( Speedmaster has the $$$$$ ), but as Broader said, in the video, just have to be smarter.

Wow. Great share.....hope this gets seen far and wide.

Good little video about what speedmaster products do...

 https://youtu.be/9dsHrSq8pso

I am , aware of how this Aussie based company runs, ( even a couple of Americans on board) they have lawyers, and lots of $$$$$$. This part  the original Broader valvebody, was sent out for bid, an a bid accepted. Reverse engineering,  but someone,  forgot to tell, that the Broader Performance,  logo should not be on the part.  Should the parts be scrapped,  or just sell them, and let the lawyers, settle any repercussions.  Obviously Speedmaster management chose , the latter.  Since it is an Aussie company, should not be too big a deal, to have them stop selling parts with Broader's logo machined in. However Barry , is correct, it won't stop Speedmaster, from doing, what their business model, has been since their founding. And for Doug, Summit didn't  know who or what Broader Perfomance is, though they probably  do now.

Any play in the pinion? Does the yoke have cap locating tabs or need u-joint clips?

If the only thing changed is the center section, I'd be hard pressed to blame the driveshaft