Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - feadam

Pages: 1 [2] 3 4 ... 7
16
FE Technical Forum / Re: Lima roller lifter vs FE difference
« on: February 04, 2020, 07:06:03 AM »
Thanks

17
FE Technical Forum / Re: Lima roller lifter vs FE difference
« on: February 04, 2020, 05:57:27 AM »
Just wondering I have lunati hyd roller lifters and if I remember they were listed as being for both, are they the same as crower

18
Vendor Classifieds / Re: Get on the list for the FE Power Cylinder Head Package
« on: November 02, 2019, 06:55:33 AM »
any update on progress Jay ?

19
FE Technical Forum / Re: "Flow numbers"
« on: June 20, 2019, 03:45:36 PM »
Will the new high risers have better numbers in and ex than this

20
FE Technical Forum / Re: timing pointer screws
« on: March 16, 2019, 09:10:38 PM »
thanks its always the little crap that i cant find when building engine, i know i had them

21
FE Technical Forum / timing pointer screws
« on: March 16, 2019, 05:45:55 PM »
Anybody know the size for the screws that hold timing pointer?

22
FE Technical Forum / Re: FE Power Cylinder Heads
« on: March 14, 2019, 01:26:26 PM »
Jay
as cast what kind of flow numbers are you guessing the heads will flow?


23
FE Technical Forum / Re: FE Power Cylinder Heads
« on: March 11, 2019, 07:37:57 PM »
jay
will these heads require special pistons?

24
FE Technical Forum / Re: fuel pump
« on: March 09, 2019, 12:03:15 PM »
the pump i have has it in, can i just change it to a 3/8

25
FE Technical Forum / fuel pump
« on: March 08, 2019, 05:45:24 PM »
which fuel pump for fe comes with 3/8 inlet and outlet?

26
FE Technical Forum / Re: FE Power Cylinder Heads
« on: February 26, 2019, 08:31:45 AM »
Any update pictures on heads, machining?

27
FE Technical Forum / Re: Compare Dove Heads To Other Manufacture's ?
« on: August 20, 2018, 05:01:17 PM »
Any idea what they are gonna do with molds for parts?

28
FE Technical Forum / Re: Compare Dove Heads To Other Manufacture's ?
« on: August 19, 2018, 12:19:07 PM »
Did Dove go out of business?

29
FE Technical Forum / Re: Clutch arm
« on: May 07, 2018, 02:07:07 PM »
so ordered a new fork and bracket from MACS today. This cobra is getting expensive, arm and bracket were 130

30
FE Technical Forum / Re: Clutch arm
« on: May 07, 2018, 08:28:54 AM »
I have small input trans but big input later 428 arm, can i still use arm? everything seems to work other than bracket

Pages: 1 [2] 3 4 ... 7