16
FE Technical Forum / Re: Cammer at MCACN
« on: November 23, 2023, 11:43:57 AM »
100k is ridiculous, it looks peppered with repop parts. I'd be embarrassed to show my face asking that kind of money for that engine.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have 4 or 5 used cams out of 360/390 mills.
Will mike them and see what the lifts are and look at the lobes
You can have free ............ how soon do you need one ??
Ricky.
I have a Engle 3271H cam I ran in a old dessert race truck 225 @ 50 510 lift single pattern 110 LSA
great torque and low end throttle response and I have a Edelbrock performer 390 ,not performer rpm, port matched to C7AEA heads , again great low end but is done making power by 4700 rpm. PM me if your interested
Pond ordered some (quite a few) from Comp and they never actually made them....
AFAIK, they don't have typical SOHC cores in stock.
The cams I have made are custom made from a big round lobe billet core. Not cheap and a nice lead time.
Never been a big fan of the pentroofs, but it's an option. Another option is a pair of M/T covers with no holes, but they're getting harder and harder to find in good condition.