Thank you Earl..............Tom

Does anybody have a picture of the graham rockers they could post so i can see what they look like??? Are they still in business yet?? Afret or anybody, thanks..........Tom

Hi, could you please post a pic or 2 of the 650 carb, is it vacuum sec??  thanks...……..Tom

It shows on the old 'Amber Green' dragway @ Eau Claire witch is now Rockfalls that Clyde Birch raced it for awhile...........Tom

Ls....'Lip Service'

For sale is a nice used 288r roller cam and lifters, this cam was in a 427 a close friend bought, the lifters were sent back to comp for rebuilding and 2 were replaced. Engine had about 45 minutes to an hour run time on the test stand, and some dyno pulls,  then about 200 street miles. He went a different direction and no longer needs this. Asking $495.00 for the set, plus the ride.  Specs are .645 lift 292 adv. duration 243@.050 and 110lobe center 106 int.c/l lash is .020/.020  Listing for a friend, he does not have access to the forum...............Tom

I quess this question is for the likes of Blair or Brent.... any updates when the manifold will be released???...........Tom

Dieselman, instead of blowing all that money4 cometics  too bad you could not find at set of the old Ford steel  shim .015 or .020 thick gaskets............Tom