Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - centredautomag

Pages: 1 2 [3]
31
FE Technical Forum / Re: cylinder bore
« on: December 24, 2018, 01:39:46 PM »
I as been bore and hone with torque plate . I guess the machine shop didn't notice it before ordering the piston.I look like mini rust spot if you look at it carefully.
Clearance are at .0045 to .0047 on all cylinder with Mahle forge piston.

32
FE Technical Forum / cylinder bore
« on: December 24, 2018, 10:04:43 AM »
I was gapping my rings yesterday and notice a shadow on top of the cylinder wall,I can catch my fingernail on it.

Do you guys think it is time to put a sleeve in?   Thanks Marc.

33
FE Technical Forum / bearing clearance
« on: December 19, 2018, 04:06:14 PM »
Check main and rod clearance last night  I have .002 on main and .003 to.0035 on rods
I will get a set of rod bearing to go down to.0025. the question is ,should Igo up to.0025 or stay at .002.on main.
It is a scat rotating kit .The car is mostly street driven.

34
FE Technical Forum / Re: main bearing gallery modification
« on: December 18, 2018, 05:40:11 PM »
It is exactly like mine look before I blend the opening in the block. Did not look that bad with stock
Bearing ( round hole).

35
FE Technical Forum / Re: main bearing gallery modification
« on: December 17, 2018, 03:47:24 PM »
OK will do. thanks.

36
FE Technical Forum / Re: main bearing gallery modification
« on: December 17, 2018, 03:31:51 PM »
Thank you Brent  I did blend the hole  do you think I should  blend some more .

37
FE Technical Forum / main bearing gallery modification
« on: December 17, 2018, 12:37:48 PM »
I installed race main bearing yesterday with block modification I want to know if I am good to go or  do I have to enlarge the gallery a bit more  thanks

38
FE Technical Forum / Re: clutch choice
« on: December 15, 2018, 08:59:31 AM »
Thank you evrebody Iwill bid on the mcleod kit. If i can`t get it at a good price I will go for the ram kit. Marc.
 

39
FE Technical Forum / Re: clutch choice
« on: December 13, 2018, 01:52:27 PM »
engine not completely done yet. hoping for 550 to 600 hp tq.
Brent i got a set of cnc pond head and a custom cam from you last year.
car will be driven most of the time on the street
the kit is on ebay now. if not what need can you make a sugestion i can wait a bit  longer.

40
FE Technical Forum / clutch choice
« on: December 13, 2018, 09:15:52 AM »
will be putting my 482 in my 63 galaxie would a mcleod 360825 p.plate and 260863 disk be ok.
car as 3.89 gears 29in. cheeter slicks and big in out top loader trans. thank

Pages: 1 2 [3]