What is ICON Pistons ?? Never heard of them
Any one  who have used them??

Any one with a GV OD in a 64 Galaxie
Did you have to cut the floor ?

My friends 38 Plymouth coupe https://www.youtube.com/watch?v=SN7WScS0amM
found it looking on youtube

Me and a friend are going to USA in september to pick up a
Model T center door he bought and we are going to visit
T-bucket nationals ,Race of gentlemans,Carlisle swap meet
and some sprintcar race.And if possible pick up my parts
from Barry-R at survival
Would be fun its 10 -15 years since i last went

     https://www.youtube.com/watch?v=jbiSo3ApGdw&list=RDjbiSo3ApGdw#t=84

some Rallycars from Sweden https://www.youtube.com/watch?v=vjsUOLgDNOw https://www.youtube.com/watch?v=5_13-2Rv_SY

Finaly i had some time to use on my own toys.
Earlier i tore down my 64 PI 390 and it was in
misserable condition with scratced cylinders
bored 060.It was bored to thight, bent rods
bad crank.cam,etc,etc
So i tore down another 390 that leaked water
in the oil.Pressure tested it and found a crack
i welded.And it got some rust in some cylinders,
so i got my self a Sunnen portable hone to hone
out the rust to see if i had to bore it
Today i tested the hone on the PI block just to
test it and get a feel for it. And with a cyl cleaned
up i still have material to hone before im at max
piston clearance. So im able to save the block thats
original for the 64Galaxie
So i save that for later and build on the other block.
Its bored 030 but is not realy run after that beacuse
of the water issue.
So if the rust cleans up i can order a stroker kit with
030 pistons and line hone and deck the block
So tomorow i hope i have time to make a torque plate
so i can hone the cylinders and see if i can run it or
have to go 040 over