Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bluedude428

Pages: [1]
1
FE Technical Forum / Re: C6AER head porting/clean-up exhaust
« on: January 06, 2019, 09:33:04 PM »
Thanks for the info guys, Joe especially...…..glad to be a part of the FE club!
Joe did you get my PM, just wondering if I got it right
                                                                                          Bob

2
FE Technical Forum / Re: C6AER head porting/clean-up exhaust
« on: January 05, 2019, 03:48:17 AM »
Joe when you refer to "short turn" on your reply what does that refer to? I agree with the  majority of flow being at the top of the port as well which is why "thermatacor" area of the port really gets most of my attention as something to be dealt with. How much of that area , especially the flat spot, can be removed. Is it possible to grind/blend completely smooth? …….Bob

3
FE Technical Forum / C6AER head porting/clean-up exhaust
« on: January 04, 2019, 01:20:00 PM »
Hi everyone, I am new to the sight and need some experienced input on porting and cleanup on my C6AER heads mostly on the exhaust. Are the humps in the lower corners there for a reason to add velocity, or are they a hinderance to flow? I know the upper thermatacor humps are a hinderance but how much can they ground away. Just concerned if any possibility of running into water jackets...….so I have been told. Intake info also appreciated Thanks......

Pages: [1]