Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Buckwheat

Pages: [1] 2
1
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: July 06, 2020, 07:56:36 PM »
Mine is no longer available.

2
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:57:39 PM »
Last

3
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:55:48 PM »
5

4
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:54:53 PM »
4

5
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:54:12 PM »
3

6
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:53:42 PM »
2

7
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 29, 2020, 07:52:46 PM »
Pics

8
Vendor Classifieds / Re: Looking for a Holley 950 3-bbl core....
« on: June 28, 2020, 05:04:06 PM »
I have a 950 or 1050 in storage, can check tomorrow and get pics and the numbers.

9
Vendor Classifieds / Re: FE Power Cast Aluminum Valve Covers
« on: September 06, 2018, 09:01:12 PM »
Jay, can you do the cobra jet emblem?

10
FE Technical Forum / Re: Guess the horsepower game....
« on: September 06, 2018, 08:45:13 PM »
518

11
Private Classifieds / Comp 280H cam, lifters and timing chain set
« on: July 16, 2018, 09:12:38 PM »
Comp 280H cam, lifters and timing chain set.  All items were installed in my 428CJ but engine was never run.  Pics can be provided on request.  $125 plus shipping.

12
FE Technical Forum / Re: Engine build opinions
« on: April 29, 2018, 02:52:48 PM »
Thanks for the input.  You are running a really tall tire (28”), I expect to run something closer to a 26” which would put our axle ratio almost identical.  I am running 3” exhaust back to spin tech mufflers, then 2 1/2” out the side in front of the rear tires. 

13
FE Technical Forum / Re: Engine build opinions
« on: April 28, 2018, 07:20:47 PM »
Not too late, thanks for the input.  Trans has .64 od, haven’t picked out tire size yet which will make a little difference on cruise rpm.  I understand the benefits and plan on spending a lot of time on the heads.  What are the details on your 489 FE build?

14
FE Technical Forum / Re: Engine build opinions
« on: April 26, 2018, 09:03:31 PM »
Hydraulic roller is good, I sent you an email if you would prefer to quote that way.

15
FE Technical Forum / Re: Engine build opinions
« on: April 26, 2018, 03:49:13 PM »
$1250 doesn’t scare me if it’s the right way to go.

Pages: [1] 2