Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Arizona ‘58Mercury

Pages: [1]
1
FE Technical Forum / Edelbrock F427 Intake Manifold
« on: February 06, 2018, 09:50:16 PM »
Picked up this intake last week.  I know it’s older but all in all pretty good shape on all matting surfaces.  Only question is on a few of the corners of the pushrods passages they are clearances and not sure if from damage or not.  Can post a pic. Will it affect operation, if so options?

2
FE Technical Forum / Pushrods
« on: February 04, 2018, 10:23:19 PM »
Just got a set of factory Adjustable Rocker assembly’s for my 390.  So I need the cup and ball pushrods.  What companies do you recommend?  I have see 2 different diameters as well as a few different lengths that they say are stock.  I don’t have the pushrods for the existing motor to measure.  It is out of a ‘65 Tbird and has C4 heads if that matters.  Any suggestions would be appreciated, Thank you.

3
FE Technical Forum / Radiators that for Desert heat
« on: December 25, 2017, 11:43:40 AM »
So living in Hell, aka Phoenix Az.  For the most part the motor is stock 390 from a 65 tbird and going into a 58 Merc Monterey.  Not planning on a whole lot of summer driving but even now it’s in the 60’s and 70’s.  Any suggestions on radiators that flow and cool more efficiently?  Thanks in advance

4
Non-FE Discussion Forum / MEL Motor and Trans
« on: December 12, 2017, 01:59:10 PM »
Not sure we’re to ask or find out so I figured I would ask you guys.  As the MEL board I found was dead.  Any demand for the old 383 MEL or interchangeable parts to different motors.  I’m pulling out the 383 of my 58 Monterey along with the trans and dropping in a 390Fe.  Thanks in advance.

Pages: [1]