Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Joey.S

Pages: [1]
1
FE Technical Forum / Re: Looking For a Cast Iron Cam Gear
« on: September 29, 2022, 03:50:21 PM »
Hi,
 Thanks for  the reply guys,  I found out today the Napa DG306 is the same as the standard ign DG18.

 I just wanted to be 120% sure I had the right gear.

 Joey.S

2
FE Technical Forum / Looking For a Cast Iron Cam Gear
« on: September 28, 2022, 08:41:51 AM »

 Hi guys,

 My question is I'm looking for a cast cam gear for my flat tappet cam,  Is anyone familiar with the Napa (Echlin) DG306? 
 I was told it's a stock replacement gear which should be cast but I want to make sure just curious if anyone has used on of these gears it does have a much smoother finish then my original one.   I also did reach out to Brent, Barry and a couple other FE shops but they have no stock on Iron gears for the ford duraspark distributor  .467 shaft.

 Thanks in advance for any help.
 Joe

Pages: [1]