Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - temarey

Pages: [1]
1
A Malco HC2 will cut 2 inch to 20 inch round hole

2
Link worked for me
Interesting read ,but not surprising in today's corporate world

3
FE Technical Forum / Re: Tri-Power or Dual Quad Offenhauser?
« on: October 19, 2018, 11:21:33 PM »
SWISH  I didn't suggest an electric motor
Fine , I'll put the holleys back on my engine

4
FE Technical Forum / Re: Tri-Power or Dual Quad Offenhauser?
« on: October 19, 2018, 10:57:53 PM »
how about 3-2V using the new FI-tech replacement for carbs

5
Four door cars can be cool. remember Gapp and Rousch  Tijuana Taxi 8.80's

6
Non-FE Discussion Forum / Re: Would you pay $47,500 for this (Ford) car?
« on: September 28, 2018, 10:30:24 PM »
C'mon road trip

7
FE Technical Forum / Re: Guess the horsepower game....
« on: September 06, 2018, 08:06:19 PM »
478 uncorrected

8
FE Technical Forum / Re: Oilpan
« on: August 27, 2018, 09:59:18 PM »
all pans fit but some windage trays will not

9
Non-FE Discussion Forum / Re: Grassroots Maverick
« on: August 25, 2018, 03:48:05 PM »
back in the dark ages when I was bracket racing at Minnesota dragways some of the most consistent winners were the slowest cars on the planet

10
FE Technical Forum / Re: Fe in 56 Ford
« on: August 05, 2018, 04:26:08 PM »
you must be old as me
I mounted the transmission on the original mount then turned the engine mounts until they fit

11
FE Technical Forum / Re: Fe in 56 Ford
« on: August 05, 2018, 02:07:52 PM »
I did that swap when I was in high school and worked in a junk yard

12
FE Technical Forum / Re: Fe in 56 Ford
« on: August 05, 2018, 09:08:57 AM »
also was original front sump FE oil pan

13
FE Technical Forum / Re: Fe in 56 Ford
« on: August 05, 2018, 09:07:15 AM »
It was a long time back , I used original motor mounts ,stock  trans crossmember  and that was with a toploader 4 speed
original clutch linkage with FE clutch pivot.
I moved the radiator in front of the radiator cradle for fan clearence
exhaust was log manifolds ,so I don't know about header fit

14
Check that the converter hub is centered with the pump hub.
I have seen them not match and it causes odd vibrations.

Pages: [1]