Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DA

Pages: [1]
1
FE Technical Forum / Re: TFS Tunnel Wedge Carb options
« on: July 07, 2025, 03:45:26 PM »
Tunnel wedge - I'm sorry for that confusion.

2
FE Technical Forum / Re: TFS Tunnel Ram Carb options
« on: July 06, 2025, 01:26:30 PM »
390 .030 over
Molnar rods/DSS flat tops
TFS heads
After machine work should be about 11:1
Solid roller - 256/268 @109 about .700 lift
TKX transmission
4:30 spool rear end

1964 Galaxie SS clone.
Just to take to the strip and fun around in the brackets.

Trying to work out the top end.
I like the idea of the TFS intake, for period looks, but I've also thought about the Victor with a single and a small nitrous shot.
Modern Holley or Quick Fuel carbs.

Just trying to get some ideas...

Thanks.


3
FE Technical Forum / Re: Max effort 390FE
« on: July 06, 2025, 01:08:50 PM »
For me, 390 is 390 within the realm of a bore to clean up cylinders.
A 445 is a 445, not a 390.

My thought was no power adder, any head/intake combo.
No streetable manners, etc...

4
FE Technical Forum / Max effort 390FE
« on: July 06, 2025, 09:17:41 AM »
Has anybody done one?

What is the max HP/TQ that could be made?

Fairly general question, but it'll start some chatter.

Thanks!

5
FE Technical Forum / TFS Tunnel Wedge Carb options
« on: July 06, 2025, 09:15:04 AM »
What carb set-up for the tunnel wedge?
Off the shelf it looks like the 1850s are pretty much it.
Can I run side mounted carbs on it if I set up the linkage?

Anybody that has run one tell me about your go-to!

Thanks.

Pages: [1]