Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Fireater1968

Pages: [1]
1
FE Technical Forum / Re: Well built 390. Edelbrock rpm heads close to 10:1 compression
« on: June 08, 2025, 10:38:34 PM »
Perhaps this instead
Howard's 253745-12  adv dur 280 286 .050 dur 227 233 .lift 525 .525 separation 112 intake center 108

2
FE Technical Forum / Re: Well built 390. Edelbrock rpm heads close to 10:1 compression
« on: June 08, 2025, 03:31:26 PM »
K. Well it's a zero decked block. Flat top piston .030 over . H beam rods hand has a comp cam HYDRAULIC ROLLER – High performance for street cars with 2200+ stall, 9:1+ compression, headers. Hyd. Hyd. 2200-5800 34-432-9 XR280HR 282 288 .050 duration 230 236 .lift .521 .532 ..lobe 110

But it too much cam for enjoyable driving.  Yes i have a 2400 rpm stall convertor...my gearing is too high for this setup. And it either change gears and make it more crazy or less cam and enjoy a good running 390

3
FE Technical Forum / Well built 390. Edelbrock rpm heads close to 10:1 compression
« on: June 07, 2025, 07:58:14 PM »
What do you think of this cam for a roller fe
Howard's 256425-12

256425-12 adv duration 267 277 .050 due 215 225 lift .547 .547 lobe sep112 108 Hyd. Hyd. 1,13 98117-K3210 1200-5200 Street Force™ 2, Good idle & throttle

4
FE Technical Forum / Headers for edlebrock Cobrajet heads 79 f150
« on: April 07, 2023, 11:51:03 AM »
Any ideas on headers to fit my 79f150 2wd with 390 and edlebrock performer rpm heads?  Everyone's header flanges are for stock fe truck heads.

5
FE Technical Forum / Re: Fe starter
« on: July 13, 2021, 08:53:56 AM »
and what was your findings?

Pages: [1]