Anyone install a aod trans on there FE? I currently have a TKO600 and thinking I might want  to swap for a AOD .Is  there  one about the same size as a tko600?
Jon

Jon,
 i have one in my kellison, been in about 12 years now. mine has a manual valve body. built by FB Performance.

https://www.fbperformance.com/ViewTransmission/?TransmissionID=44


Phone
(631) 242 - 0008 (In NY)
(800) 769 - 1118 (Out of State)

Facsimile
(631) 243 - 3054

Mail
FB Performance Transmissions, Inc.
85 Cleveland Ave.
Bay Shore, N.Y. 11706

Jon, make sure #7 and #8 wires are not next to each other on your wire loom or anywhere else for that matter

this is just shocking......


just couldn't resist

originally they just spit on the ground, you can route the hose to a recovery if you like.

Fred

oh FYI, it will only be one way....meaning it will only expel fluid it won't suck it back in. so it will only save you a wet spot on the ground.

if i was buying a set after what i learned from the last set, in addition to the above statements, i would put thread inserts into the intake threads and open up the drainback holes.
and check the locations of the intake holes too.......mass production has a little to be desired when there is a lack of QC.
to the statement of "hasn't anyone complained"? the answer is of course people have complained, but if their experience was anything like mine, edelbrock
cops an attitude and makes statements like "thats impossible" "because we are edelbrock sir"
edelbrock is no different than any other aftermarket manufacturer.....you have to trust nothing and check everything

i agree, i have the same VC's and had to clearance a bit of the inside of the VC to keep a rocker from hitting, it made the same noise

i wouldn't use the 15-40 for breakin......get either brad penn breakin 30 weight, or some joe gibbs breakin oil
you can get the brad penn here.....
http://theoilwarehouse.com/?mainURL=/store/category/d4aw/Racing_Oil.html

Ya' know pinions are like butt holes..........