1
FE Technical Forum / Re: Dove remote oil adapter
« on: April 03, 2016, 07:22:30 PM »
Thank you very much. Senior moments come and go! Sincerely, Richard!!!
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
FE Technical Forum / Re: Dove remote oil adapter
« on: April 03, 2016, 05:58:27 PM »
Thanks for the oil filter picture! Unfortunately, I'm using a remote block bolt on adapter, I attach one line from a fitting on the block adapter, that goes to the in port of the remotely located dual oil filter mount. The out port on the remote filter adapter goes on the port returning to the adapter bolted to the block. Thank you for your attempt. I need other information; picture preferred. Thank you! Sincerely,Richard
3
FE Technical Forum / Dove remote oil adapter
« on: April 02, 2016, 09:24:23 PM »
Hello fellow F.E. Guys; I'm a little older now, and would like to refresh my mind about orientation of the feed and return lines on this adapter, Please. A Picture would sure be greatly appreciated! One line will be going directly to the in port of my dual filter assembly; the other will be routed from the out port returning to the side of the block. Thank you all in advance. F.E. guys are GREAT! Sincerely, Richard Paul Metzger
4
Private Classifieds / Wanted N.O.S Stewart Warner 2-5/8" 1970S racing volt gauge.
« on: March 02, 2016, 07:58:01 PM »
I have been shopping years for a N.O.S. or good condition Stewart Warner 2-5/8 inch volt racing gauge. Chrome outer ring ,black back round ,white numbers and word volt. Thank you. Richard Metzger -ralphandalice1@comcast.net;Baltimore,Maryland,21234
5
Vendor Classifieds / Re: FE Timing Covers
« on: February 07, 2016, 07:40:10 PM »
Hi Jay, Adjusting the valves with the engine running? Thanks, Richard
6
Vendor Classifieds / Re: FE Timing Covers
« on: February 07, 2016, 12:33:45 PM »
Hi Jay, Any plans for two piece valve covers? Removeable top! Thanks Richard
Pages: [1]