1
FE Technical Forum / Re: need some advice asap about building my 390fe motor?
« on: April 13, 2015, 09:33:08 PM »
sorry I do have the performer rpm intake already, so that's a plus for me
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
FE Technical Forum / Re: need some advice asap about building my 390fe motor?
« on: April 13, 2015, 07:53:14 PM »
also best stall speed to use? ignition? and I was thinking about headers but always hear horror storys about them leaking, no room to change plugs, and scrapping issues. I was reading about the set of factory manifolds that work well? and I have a set or 2 of them.
3
FE Technical Forum / need some advice asap about building my 390fe motor?
« on: April 13, 2015, 07:49:19 PM »
hi guys im in the process of having my 390fe built but I haven't made any decisions yet. I have the 428 heads which I plan to use. its bored 40 over now but were thinking of going to 60 over, I want it to make a lot of horse power It will be a street strip kinda car. is it hard to get say 500hp out of these motors? or close to that? anyways I need to know the best cam to use id like a nice sounding cam but I want a cam that works good also. I also have a edelbrock performer aluminum intake. suggestions for the best set ups that some have already done and are using would be great. need input on what carb to use? cam set up? pistons? also should I buy the high volume water pump? and or fuel pump? which oil pan? the motor will be going into a cougar eliminator. thanks in advance for opinions.
Pages: [1]