Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tambo

Pages: [1]
1
FE Technical Forum / Re: FE casting numbers
« on: March 28, 2022, 04:48:34 PM »
Thanks for your replies guys.
I'll check the stroke.

2
FE Technical Forum / FE casting numbers
« on: March 28, 2022, 07:16:32 AM »
I have an FE block with casting numbers C6ME-A. Mustang Tech states it could be a Mercury 410, or a 428.
Another number on the opposite side of the block is 6E5. I can't find any information on this number.
I'd appreciate any advice on either of these numbers thanks.

3
FE Technical Forum / Re: Molding tool I D ?
« on: October 21, 2018, 04:40:16 PM »
So do I Dan. Of all the cars I've had, that's the one I would have kept. Unfortunately, circumstances prevented this ... I know where it is and if I come into money, I'll try to buy it back.

4
FE Technical Forum / Re: Molding tool I D ?
« on: October 20, 2018, 06:57:02 PM »
Hey thanks for that Kevin.
Looking at your cars, I had a 66 Park Lane fastback with 410 / C6 drivetrain and a 66 Cyclone GT vert with 390 / Toploader.




5
FE Technical Forum / Molding tool I D ?
« on: October 20, 2018, 04:43:38 AM »
Just bought a 63 1/2 Galaxie running a built 428 and T 10 four speed.
There were quite a few spares and stuff in the trunk including this ... https://www.dearbornclassics.com/molding-removal-tool.html. Can anyone advise what it does and how to use it? Thanks.

Pages: [1]