1
FE Technical Forum / Re: Shout out to Jay Brown.
« on: October 23, 2014, 02:47:02 PM »
Thanks Jay!
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
FE Technical Forum / Shout out to Jay Brown.
« on: October 22, 2014, 08:26:34 PM »
Hi Jay. I'm looking to install Edelbrock heads on my 390. The catch is that the engine is in a '66 F100 and I need to use truck headers for the lower port C8 heads. I saw this pic in your article in Car Craft:
http://www.carcraft.com/techarticles/ccrp_0808_ford_390_fe/photo_17.html
Those truck headers look like my Flowtechs.
Maybe this can work and what header gaskets did you use?
Thanks!
Eric
http://www.carcraft.com/techarticles/ccrp_0808_ford_390_fe/photo_17.html
Those truck headers look like my Flowtechs.
Maybe this can work and what header gaskets did you use?
Thanks!
Eric
3
FE Technical Forum / Re: Jay I noticed you mentioned something may be worthy of your dyno testing it
« on: June 11, 2012, 07:33:56 PM »
I believe BB is referring to my post on the FE Forum. Both my '99 F150 with 4.6 and Dodge Ram with 5.9 had single catback exhaust installed using 3" pipe and Flowmaster 40's I believe. Both lost bottom end after the conversion. It was very noticeable.
Pages: [1]