1
FE Technical Forum / Re: Guess the tunnel port horsepower!
« on: November 10, 2012, 02:24:31 PM »
I'll guess 675 hp w/ 2-4's and 660 w/dominator. If I win, the tooth fairy will put a Pond "graphite" block under my pillow!
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Member Projects / Re: My FE Powered 1966 F100 "Project"
« on: February 07, 2012, 08:42:19 PM »
yea, i couldn't see the notch's in the photo's, but i kind of figured there was not enough clearance. i guess i'll just have to get a custom pan built! nuthin's easy lol. anyway, thank's for the help!
3
Member Projects / Re: My FE Powered 1966 F100 "Project"
« on: February 03, 2012, 12:45:01 PM »
never mind my previous post.i just found your pic's on the h.a.m.b. forum- i guess that moroso pan fit's! don't look much clearance, lol- thank's
4
Member Projects / Re: My FE Powered 1966 F100 "Project"
« on: February 03, 2012, 12:08:37 PM »
I hate to bother you , but did you have to trim the passenger side of the pan or did it clear as is ? before I pulled the motor ,I measured off of the stock pan and it looked like no way a t-stle pan would clear. again , thank's for the info !
5
Member Projects / Re: My FE Powered 1966 F100 "Project"
« on: February 01, 2012, 01:02:06 PM »
i would like to know who fabricated your oil pan , as i have 66 f250-2 wd -i can't go deep sump and the t-style's hit the cross member on the pass. side--I currently have a sideoiler being buit over at survival motorsports and would like to get pan sent to him in the next month or so. also what motor mounts (or mod's) did you use,as last time i had to drill the stock fe's as i recall? any info would really help me out ,thanks -gene p.s. i thought mine was "clean" until i saw your's on the "h.a.m.b post" and here !!!
Pages: [1]