1621
Non-FE Discussion Forum / Re: Americantorque dash board quiz.....not that easy.
« on: November 24, 2015, 11:16:30 AM »
Only got 48 percent cool though if it was to easy it wouldn't be fun
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
1622
FE Technical Forum / Re: New blocks
« on: November 15, 2015, 08:00:06 AM »
I remember the room full of BBM blocks looked like hundreds I guess there moving along nicely
1623
FE Technical Forum / Re: First oil change
« on: November 15, 2015, 07:54:14 AM »
Thanks guys this is new to me I have been using castrol 20-50 since I am a kid never had any problems I guess times are changing or I am reading too much
1624
FE Technical Forum / Re: First oil change
« on: November 14, 2015, 10:38:23 PM »
That's what I used to break it in so use their regular 10-30 oil flat tappet bye the way
1625
FE Technical Forum / First oil change
« on: November 14, 2015, 10:22:40 PM »
So motor was broke in open filter and was clean, install new filter make some adjustments and drove for about 10 miles. Want to do first oil change what oil is everyone running ( solid cam)
WHICH OIL
WEIGHT
WHICH OIL
WEIGHT
1626
Non-FE Discussion Forum / Re: Jetmen (jet backpack) fly alongside airliner!
« on: November 10, 2015, 12:11:39 PM »
I wasn't thinking altitude because you can see the ground but the speed
1627
Non-FE Discussion Forum / Re: Jetmen (jet backpack) fly alongside airliner!
« on: November 09, 2015, 11:01:48 PM »
How fast are they going. Do they need like oxygen tanks
1628
FE Technical Forum / Re: Spark plug hole cracks in highriser heads
« on: November 05, 2015, 08:53:35 PM »
Yeah done a few of them also had a few customers that wouldnt change their plugs unless they had a problem almost always the second or third on pass side
1629
FE Technical Forum / Re: Strokers
« on: November 04, 2015, 02:16:31 PM »
Amen, enjoy the gas prices while we can
1630
FE Technical Forum / Re: Intakes
« on: November 02, 2015, 10:13:28 PM »
Thanks guys I dont know alot about the edels but I do like that the manifold is 300 cheaper and I am partial to the holleys which Im fairly good at
1632
FE Technical Forum / Re: pulleys
« on: November 01, 2015, 09:04:50 PM »
Good to hear you think you got it
1633
FE Technical Forum / Re: Intakes
« on: November 01, 2015, 08:56:12 PM »
What do you think the difference in horsepower is between Holley and edelbrock with comparable cfm
1634
FE Technical Forum / Re: Intakes
« on: November 01, 2015, 04:46:03 PM »
To bad for the price would be great plus they would sell a hell of a lot more if you could put holleys on it JMO
1635
FE Technical Forum / Re: Intakes
« on: November 01, 2015, 12:38:37 PM »
I didn't realize you couldn't use holleys