Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 6569fe

Pages: 1 [2]
16
FE Technical Forum / Re: rocker wear pattern
« on: March 06, 2019, 11:58:09 AM »
Howdy again,
Using Harland Sharp roller tip rockers.
Started out by using adjustable length push rod to get length.
Pattern is centered on valve tip but .120-.125 in width.
What a learning experience.
Larry

17
FE Technical Forum / rocker wear pattern
« on: March 05, 2019, 08:09:58 PM »
Howdy,
Really great info here, some sharp individuals.
I have checked numerous times trying to get a rocker wear pattern as small as possible, have seen here that guys have been able to get to .060 pattern width. I haven't been able to get that narrow, .120-.125 is approx where I seem to end up.
My question is,
Is there a starting point, as far as stem height, rocker shaft center line to head or?
And since heads warp and twist are you milling the pad mount on top side of head?
Appreciate the help,
Thanks, Larry

Pages: 1 [2]