Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dubs1

Pages: 1 [2] 3 4 ... 8
16
Private Classifieds / Re: NEED SHIFTER ASSEMBLY 65 TO 68 4 SPEED TOPLOADER TRANNY
« on: October 10, 2023, 07:03:43 PM »
THANK YOU VAL.  i WILL GIVE  HIM A CALL

ALL THE BEST

LARRY  IN DENVER

17
Private Classifieds / NEED SHIFTER ASSEMBLY 65 TO 68 4 SPEED TOPLOADER TRANNY
« on: October 09, 2023, 03:24:00 PM »
Hi  Guys

I need to find   a shifter assembly  for a  67 4 speed toploader.  I have  all the rods, and handle but need the piece  that bolts to the rear tailhousing  on the toploader.  I prefer one  not needing  rebuilding  i e  fully operational with no issues.

Pls advise  cost  and shipping to  zip code  80112   (720 8393477)  ltduba@hotmail.com

All the best

Larry in Denver





18
Private Classifieds / WTB USED 1968 MUSTANG 4 SPEED EXTENSION HOUSING
« on: August 18, 2023, 11:17:22 AM »
Pls excuse  my typo  in the previous post

I need  a 1968  extension housing

Larry sends

Previous Post:

I need a used   toploader  4 speed  extension  housing case  for my 68 Mustang  FB.

Pls include  price and  estimated shipping cost to zip code 80112 in  Colorado

Pls advise

Larry in Denver    ltduba@hotmail.com    (720) 8393477


Many Thanks

19
Private Classifieds / Metering jets for an Autolite 4100
« on: July 19, 2023, 06:07:38 PM »
Pls forward me  a source for jets for an Autolite  4100  carb

Thanks

Larry

20
FE Technical Forum / Re: FE/EDELBROCK WATER PUMP ISSUE
« on: May 03, 2023, 09:03:37 PM »
Thank you fellas  !!!

21
FE Technical Forum / Re: FE/EDELBROCK WATER PUMP ISSUE
« on: April 30, 2023, 03:49:49 PM »
Pls forget my last question fellows,  Being an old fart  and  near cited   I am only blind  in one eye  I just cant see outa the other,  the Edelbrock outlet is in fact  OD  two inches. 

22
FE Technical Forum / FE/EDELBROCK WATER PUMP ISSUE
« on: April 29, 2023, 09:22:38 PM »
Does anyone  have  a brand name  or  make  of a radiator  hose to fit the 2 1/4  outlet  for the Edelbrock FE water pump.  I have checked with local  auto part stores and  they dont have any hose in stock that size.

Pls advise

Larry   in Denver


23
Non-FE Discussion Forum / Re: E brake interference on 66 Shelby/w Hurst shifter
« on: April 25, 2023, 01:00:27 PM »
Thank you folks.  I am going to weld in a fairlead to channel the cable clear  of the hurst shifter.  And yes it does hang down farther than  the stock shifter with major interference.

24
Non-FE Discussion Forum / E brake interference on 66 Shelby/w Hurst shifter
« on: April 22, 2023, 12:46:26 PM »
I have an interference  problem  from the  E brake cable rubbing against  the Hurst shifter.  Has anyone  had a similar problem and how did you correct the contact?

Thank you for any suggestions.

Ted

25
Non-FE Discussion Forum / Re: Cheapo laser rust remover. Seems to good to be true. Anyone see this ad?
« on: April 22, 2023, 12:39:26 PM »
I use muratic acid  from  HOME DEPOT,  Inexpensive  and very very effective, totally water soluable for  disposal

Larry

26
Non-FE Discussion Forum / Re: Ranchero Auto to Manual Conversion and More
« on: April 05, 2023, 01:09:40 PM »
I have the complete brake and clutch assembly along with housing that supports  the pedals.  SEnd meyour email and I will send you the pictures of the  assembly.  Asking $100  plus the ride from  Denver.  These came off of a 73 Ranchero.

Larry sends   720 8393477   or ltduba@hotmail.com

27
Private Classifieds / Re: Mustang 68 toploader extension housing 14Inch
« on: April 05, 2023, 01:02:36 PM »
its for a 28 spline  shaft

28
Private Classifieds / Re: Mustang 68 toploader extension housing 14Inch
« on: March 27, 2023, 01:08:44 PM »
I believe   there are a lot of used ones available.  Hoping  to find one.

Larry

29
Private Classifieds / Mustang 68 toploader extension housing 14Inch
« on: March 26, 2023, 08:15:13 PM »
WTB   Toploader tranny extension housing  for 68 stang  14 inch size.   Shipping  to  zip 80112

Larry In Denver

7208393477  ltduba@hotmail.com

30
Private Classifieds / Selliing 1965 Ford Mustang K code convertible
« on: February 18, 2023, 01:33:32 PM »
I am offering for sale  a 1965  Mustang K code GT convertible.  Fresh engine rebuild .20 over original  289 V8, date code 4H4 ( August 64 cast date)  with all the hipo parts and Hydralic roller cam to Hipo cam specs, roller rockers, 15 inch style bone wheels and new redline tires, center console, all  saddle leather interior, K code rally pack, original Northern California car in that there is no rust.  Painted  Shelby blue, factory 4 speed, original 9 inch rear end, standard 3:89 rear axle ratio, one inch sway bar, disk front brakes, 2.5 inch rear drum brakes.  Power top. Beautiful  in appearance and a very fast car.  One of 100 K Code convertibles  offered by Ford for sale in 1965.  Asking $80000/ offer.
Call or Email for pictures  (720) 839-3477  ltduba@hotmail.com.

Larry in Denver
 

Pages: 1 [2] 3 4 ... 8