Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 428kidd

Pages: [1] 2 3 ... 29
1
FE Technical Forum / Re: Would you run this rocker?
« on: June 14, 2024, 07:00:27 AM »
Maybe see if any one here might have one the could loan you until T&D gets them done?

2
David Garton owned the last production 68 1/2 mustang  . The production date on that car was 8G29.

3
Non-FE Discussion Forum / Re: Wifes nephew
« on: May 21, 2024, 07:14:34 AM »
I got double- hooked in 1967. Ed Lowther let me sit in his 427 Cobra, running, at the Glen 500 at Watkins Glen. And I went for a ride in a '64 R-code Galaxie 500

Damn Gene thats just hard to top!

4
Non-FE Discussion Forum / Re: Wifes nephew
« on: May 20, 2024, 07:36:48 AM »
Heo they may be hope out there after all! Thanks for posting that!

5
FE Technical Forum / Re: Another internet FE build
« on: May 17, 2024, 07:30:07 AM »
First time ive ever heard anyone say that a 428 was thicker than a 390 or 360 block.

6
Should be just fine , but general discussion would be a better place vs the classified section.

7
FE Technical Forum / Re: Speedmaster latest theft of property video
« on: April 17, 2024, 07:27:19 AM »
Agreed wished more people would try that and they wouldn't be out there making this stuff. Its consumer driven, as long is someone is out there looking to buy this stuff , in the name of saving a dollar then it will be out there.   

8
FE Technical Forum / Speedmaster latest theft of property video
« on: April 12, 2024, 07:47:59 AM »
Good little video about what speedmaster products do...

 https://youtu.be/9dsHrSq8pso

9
Private Classifieds / Re: ISO 63-64 Single High Riser Head
« on: April 08, 2024, 07:27:56 AM »
There are slight differences in 63 and 64 and even the 70 dated 64 casting head. It would be better to look for one exactly like the one good one you have. Casting number and with or with out date code will set that apart.

10
Private Classifieds / Re: 406
« on: April 02, 2024, 07:33:45 AM »
GA hit me up i know a guy that has a complete std bore 406 3X2 engine.  Forrestsraiders@yahoo.com

11
yeap...

13
FE Technical Forum / Re: Turning Solid Drag Rotors?
« on: March 29, 2024, 07:29:23 AM »
The problem is thickness, if there already at minimal thickness and there cut down again they will warp again faster than the last time. I would try to find a manufactures minimal thickness spec before turning them down. 

14
Private Classifieds / Re: eBay listing
« on: March 28, 2024, 07:35:08 AM »
I would think yes.

15
Non-FE Discussion Forum / Re: Calliope Engine Project
« on: March 12, 2024, 07:17:22 AM »
I said this over on Fb, but congrats to both you guys for getting together and making this happen. It isnt like this is any small task , this is a huge undertaking and not for the faint of heart!

Pages: [1] 2 3 ... 29