1
FE Technical Forum / Re: 1966 FE Galaxie Rear Suspension Advice
« on: September 27, 2018, 10:35:00 PM »
I've got a '66 Galaxie with the Spohn rear end setup and I think it's a pretty dramatic improvement over the stock system. I haven't run a rear sway bar though, and I did change the factory springs for some from coilsprings.com that were 20% stiffer and +2" at the same time I installed the Spohn components, but for me the difference was night and day. I should note that I did re-bush and dial-in the rear end with factory components prior to this swap, but that didn't have nearly the effect I was looking for. The rear end was still loose and soft, even with fresh set of factory height springs. If I recall, Spohn had a sale around Christmas, and I waited for that to save a few $$$
Hope that helps!
Hope that helps!