FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: plovett on September 30, 2020, 10:40:39 AM
-
Hey Jay, or anybody, what type of head gaskets do you use on your blower motors? Jay, I mentioned you specifically because you have the centrifugally blown FE.
What would you use on an iron factory block with aluminum heads? Low boost like 8-10 pounds. Centrifugal blower.
Thanks,
paulie
-
Use a Cometic MLS (Multi Layer Steel) gasket, Paulie, they can handle the heat and cylinder pressure of a blown motor - Jay
-
Thanks!
-
Most certainly Cometic.
I also like putting Inconel exhaust valves in as an added defense.
-
Thanks Brent!
-
Cometics even on my lil 390 with 5# of boost. Granted it doesn't see racing pressures, but after 20 yrs I haven't touched it.
-
Cometics are great , but I use Felpro 1020's less prep less cost and I've run 12lbs of boost , never lost a gasket