FE Power Forums
FE Power Forums => Member Projects => Topic started by: Dan859 on May 13, 2019, 03:19:02 AM
-
Hi everyone,
I recently bought a 66 Fairlane, 6 cylinder, 3 speed standard transmission. I want to swap in my 482 FE (Engine info and specs are posted in the dyno section) , a 4 speed toploader trans., and a 9" rear end. For this post, I just want to deal with the transmission swap questions. The transmission is a rebuilt toploader with the big in/big out shafts. First, is that transmission generally adequate for 650HP/630TQ, or should I start looking for something else (TKO, Richmond, etc). Second, can I keep the same transmission crossmember, and/or do I need to change the transmission mount? Anything that I've missed?
Thanks in advance,
Dan
-
Transmission should be strong enough, but you may not like the close ratio gears.
Cross member should be C6/FE version.
-
I would replace the rubber mount. This is the one I have in mine:
https://www.summitracing.com/parts/ptp-6-1605-bl/overview/year/1966/make/ford/model/fairlane
-
Transmission should be strong enough, but you may not like the close ratio gears.
That's definitely a possibility. I'm only Stateside for a month, so by the time I get everything together, I'm not going to have a whole lot of time to actually drive it. At this point I want to get the running gear swapped in and just get it running and on the road. Long term, I plan on getting it changed over to a wide ratio and get a Gearvendor OD unit for it.