FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: MHarvey on November 10, 2018, 02:18:07 AM
-
How would I install a second oil pressure gauge...I believe just connecting a second gauge to the same sensor will provided a reduced reading...but where would I install the second sensor?
-
In the past, I have always just used a brass Tee fitting on the oil filter adapter, so I could retain my factory oil pressure gauge or idiot light, as well as an aftermarket mechanical gauge. Worked just fine.
-
thanks...simple and cheap
-
I did see a more cosmetic option..a sandwich adapter...but what one fits....most do not go back to 1969
-
be carefull with the brass Tee fitting, the cheap ones are cut to thin and will break off at the threads .
-
^^This.
I had one crack/break on the wagon many years ago. I ran a low pressure switch to my fuel pump. It cracked, leaked and I have to do surgery on it on a Sat at the track. Never did reinstall that switch.
-
You should be able to find a steel tee to use, instead of brass. NAPA stores typically have a selection of steel fittings.