FE Power Forums
FE Power Forums => Private Classifieds => Topic started by: fescj428 on September 02, 2018, 11:16:27 AM
-
Selling a few things that I have left over from a 69 Mustang project that is now gone. I will be building a 69 Fairlane Cobra ( clone ) car, and do not need any of the parts. Feel free to make an offer on anything as I need to move this stuff. Pictures available on request. Phone call or text is best. Located in central Ohio. Thx, Brian N 614-563-4311
1. Nice set of #6114 Hooker headers for 428 Mustang. They are about ten years old, low miles, had them blasted and high temp powder coated silver. $400
2. C5AA-A Cast bell housing. This is technically the Galaxie bell housing, but will work with Mustang/Torino. Has the hump for 11.5 inch clutch. I had it blasted and painted cast blast. Sold.
3.Repro Scott Drake Shaker air cleaner assy for 69/70 big block Mustang. This is the base setup, no snorkle or flapper........but brand new never used. $450
4. Wide ratio top loader 4 spd out of a 66 Fairlane GT 390 car. Still has tag and would need to be gone thru. $600
5. 428 flywheel, brand new but balanced. $50
6. 67 Cougar steering box with pittman arm. Was originally on a power steering car. $50
Parts that I am looking for;
1. 428CJ exhaust manifolds. Prefer the repro versions as I do not need specific date codes.
2.3.91 ring and pinion for nine inch rear.
3. 68/69 Fairlane/Torino FE C6 trans.
4. 69 Fairlane/Torino 428CJ factory H-pipe.
Thx, Brian N
-
I have a C-6 trans. Where are you located at? I want 200 for it. Iam in Texas.
Kirk
-
fescj428, what is the RUG # on the tag of the TopLoader ?
-
Parts list update. The only thing I have left at this point are the #6114 Mustang 428 headers. Nice set of headers that were blasted and high temp powder coated silver. They look very nice and were never run after the powder coating. $400. Pictures on request. Feel free to call or text. Thanks and happy holiday's! Brian 614-563-4311
-
I still have the Hooker super comp 6114 headers for 67/70 Mustang with 390 or 428. These headers are nice, blasted and high temp powder coated silver. Very nice looking, very presentable. Pictures on request. $350. Thanks, Brian N
Note; would be interested in CJ exhaust manifolds in part trade. I do not need originals or numbers, the repro versions would be fine. Thanks
-
Ok, still have the Hooker 6114 headers for 67/70 Mustang with 428. Nice headers, high temp powder coated and ready to go. I can also bring to Columbus swap if needed as I am local. Pictures on request, feel free to call or text. $300 obo. Brian 614-563-4311
-
Headers are sold! Thanks