FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: Joey.S on September 28, 2022, 08:41:51 AM

Title: Looking For a Cast Iron Cam Gear
Post by: Joey.S on September 28, 2022, 08:41:51 AM

 Hi guys,

 My question is I'm looking for a cast cam gear for my flat tappet cam,  Is anyone familiar with the Napa (Echlin) DG306? 
 I was told it's a stock replacement gear which should be cast but I want to make sure just curious if anyone has used on of these gears it does have a much smoother finish then my original one.   I also did reach out to Brent, Barry and a couple other FE shops but they have no stock on Iron gears for the ford duraspark distributor  .467 shaft.

 Thanks in advance for any help.
 Joe

Title: Re: Looking For a Cast Iron Cam Gear
Post by: fe468stroker on September 29, 2022, 10:25:36 AM

I think it would be safe to assume that it is a stock type replacement gear (cast).  If it were steel it would be triple the price.  Try contacting the manufacturer to verify.

Title: Re: Looking For a Cast Iron Cam Gear
Post by: Faron on September 29, 2022, 11:18:14 AM

Standard Ign DG18

Title: Re: Looking For a Cast Iron Cam Gear
Post by: Joey.S on September 29, 2022, 03:50:21 PM

Hi,
 Thanks for  the reply guys,  I found out today the Napa DG306 is the same as the standard ign DG18.

 I just wanted to be 120% sure I had the right gear.

 Joey.S