FE Power Forums
FE Power Forums => Non-FE Discussion Forum => Topic started by: winr1 on February 25, 2021, 08:36:31 PM
-
2.09 intake and 1.56 exhaust valve
What would the outcome be ??
No combo in mind just curious as to others thoughts or experiences
Ricky.
-
Also ...
Any small table top lathes an FE piston would fit ??
I suppose max chuck size a bit over 4 " ??
Ricky.
-
2.09 intake and 1.56 exhaust valve
What would the outcome be ??
No combo in mind just curious as to others thoughts or experiences
Ricky.
I think that is hard to answer without some more detail, Ricky. I understand you are talking hypothetical, but what situation are you talking about?. So that would be a CJ size intake valve with a stock lo-po exhaust valve?
I think it would be better than using the stock 2.03" intake valve. I think if someone had those valves laying around and was doing a stockish rebuild, they would work good. I think a 2.09/1.66" combo would be better in most instances, but if you had the 2.09/1.56" valves I would use them if all-out power was not the primary goal.
paul