FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: Keith Stevens on December 06, 2020, 12:52:39 PM

Title: Off topic slightly 67 FE Mustang factory AC hose routing.
Post by: Keith Stevens on December 06, 2020, 12:52:39 PM

I bought Original Air reproduction hoses. The liquid line has the offset at the evaporator firewall. The hoses are ran and tied down to the export brace. The material seems extremely stiff compared to the Ford hoses. When the engine torques the hoses pull push the PCV and fitting out of the valve cover grommet.
Has anyone had this issue? Does anyone have a Mustang or Cougar that is unmolested at the firewall where the AC hoses exit they could post?
I appreciate any help.

Title: Re: Off topic slightly 67 FE Mustang factory AC hose routing.
Post by: Gaugster on December 06, 2020, 06:29:33 PM

My A/C has been fiddled with some but I may have the aftermarket hoses you are referring to. My PCV tube is freestanding. Factory elbow out of stock 390 valve cover into the rear facing PCV port.

Hoses in the pics were routed along the firewall on the passenger side and only attached to the export brace on the driver's side where they fed into the compressor. Sightglass was in front close to the core support.

Title: Re: Off topic slightly 67 FE Mustang factory AC hose routing.
Post by: preaction on December 06, 2020, 08:19:49 PM

67 Mustang 390 GT.